Useful commands for Cisco Nexus zoning
Posted: February 16, 2015 Filed under: Cisco Nexus, Networking, Storage | Tags: add zones, alias, cisco nexus, device, device-alias, fibre channel, how to add zones to cisco nexus, native, nexus 5k, nexus fc, nexus native fc, zone, zones, zoneset Leave a commentAfter implementing Cisco Nexus 5ks that include native Fibre Channel switching for shops that usually don’t have dedicated SAN guys, I’m often called up sometime later to offer a refresher on how to add zones. I usually share this tidbit via email, but here it is for the internets. These commands are very similar on newer MDS models, as well.
Useful commands for Cisco Nexus zoning
Integrating Cisco MDS 9124 switches with Nexus 5500s
Posted: October 28, 2013 Filed under: Cisco Nexus, Networking | Tags: 5500, 5548, 5596, 55xx, 9124, Cisco, cisco mds, fc, fibre channel, mds, Nexus Leave a commentI wanted to take a short minute and document the addition of a few Cisco MDS 9124s to our test lab at work. The purpose of the addition in the test lab is just to show the functioning and capabilities of the devices to work together. See my previous post on configuring native FC over a Nexus 5548 and 5596. The FC-specific portions of the MDS config are very similar to the Nexus line. Here’s what the middle state looks like. I haven’t taken the time to move the NetApp FC links to the MDS switches yet (or the UCS FC links instead), but the port provisioning process will be similar to those already documented in this post and the Nexus post. The Visio of what’s configured is below followed by my MDS configuration notes.
Cisco Nexus Fibre Channel configuration template
Posted: May 23, 2013 Filed under: Cisco Nexus, Networking, Storage | Tags: 5548up, 5596up, cisco nexus, cisco ucs, device-alias, eisl, e_port, fc, fc config, fc configuration, fc end host mode, fc switch mode, fc ucs, fibre channel, fibre channel configuration template, fibre channel template, f_port, isl, n_port, te_port, tf_port, ucs, vsan, zone, zoneset, zoning 6 CommentsI recently had the opportunity to configure native fibre channel in my test lab at work using Nexus 55xx series switches and Cisco’s UCS. What I’ll do in this post is to share my templatized fibre channel configuration in a somewhat ordered way, at least from the Nexus point of view. This test lab was configured with the attitude that it should show off the capabilities of the hardware and software. Concepts included in this initial configuration include NPIV, NPV, SAN port-channels, F_Port trunking, VSANs, device aliases, and of course, standard FC concepts like zones and zonesets.
Let me first share the end-state as of today, what I’ll call Phase I. I’ll explain what my initial plan was for Phase I and, after learning a bit more, what I plan to do for Phase II. Please feel free to correct me in the comments below – I made a lot of mistakes configuring this and I wouldn’t be surprised if there’re a few more in there.